Disperator 8075-E Guía de uso y cuidado

Waste Compactor Model 8075Installation, Use & Care GuideDISPERATOR AB Mälarvägen 9, SE-141 71 Segeltorp, Sweden Ref. 8075/Inst,Oper/Eng/10112

10g) The compactor motor has an automatic thermal cutout. If compactor is run repeatedly, this protector may have opened the circuit. Wait a few minut

11

12

131441030537827830440 (built-in installation)70see*546 (incl. door)610Position of adjustable feet 4pcs.Front of compactorElectrical connection plug wi

2Grounding Instructions1. For personal safety this compactor must be properly grounded.2. A 10Amp fuse is required for compactor Model 8075-E connecte

31. Installation1.1 Unpackning the CompactorTo protect the compactor mechanism the unit is shipped from the factory with packing material in the waste

4To level the front of the compactorTip the front of the compactor up and onto a wood block. Turn the levelling legs in or out to the desired position

5bottom of the door using a small flat screwdriver. Install the bushings on the side of the door panel that will be hinged and install the caps on the

6Installation procedureRemove the disc from the foil pouch. Swing open the odor control disc door, and place disc face down on tray so that the GREEN

7At the bottom of the compaction plate stroke, the plate will stop. This setting is helpful for compressing waste for several hours until it holds its

83.3 Waste Bag Removala) Open the door and slide out the waste container.b) Release the two container latches and lower front of the container (see pi

9The compaction plate is cleaned as follows:a) Remove possible waste bag from container (see item 3.3 above).b) Push the waste container into the cab